Placement of Electroless Nickel Plating Line

Today, the editor will introduce the placement of the electroless nickel plating production line. The placement of the electroless nickel plating production line should be based on the ease of operation as the first principle.

The production equipment should be placed in the order of the established process flow. The deionized water bucket and the supplementary solution should be close to the plating tank. The plating tank should be kept a certain distance from the left and right front and post-processing areas. The finished product stacking area is best placed in another room to avoid acid mist corrosion of the workpiece.

All power cords should be covered with rubber sleeves, and should not be placed on the ground to prevent frequent footsteps, squeezing, cracking of the jacket and leakage of electricity. The ventilation device should be at a height of about 2 meters above the ground. , An exhaust device should be installed near the drying tank.

Pure water device, air compressor and some auxiliary mechanical devices are best placed in the room next to the production line. Now most electroless nickel plating solutions are acetic acid buffer system, and the complexing agent is basically lactic acid-citric acid system, so the acid gas is relatively If there are vehicles on the production line, please pay attention to brushing the protective paint. Calculate the internal volume of the workshop and arrange the exhaust device of the workshop. The production laboratory is best located in the production line. best distance.